NOTE: Rebooting the Wemo Dimmer WDS070 is not the same as performing a factory restore. Rebooting will not remove any custom settings.
Using the reboot button
The reboot button is located on the front of the Wemo Dimmer WDS070 underneath the main control buttons. Press and hold the button in for 2 seconds until the status LED flashes white and then release.
Using the fuse/breaker panel
The Wemo Dimmer WDS070 can also be rebooted by cutting power to it at your fuse or breaker panel. This method should only be done if you are unable to access the Wemo Dimmer WDS070 unit or if the reboot button is not working.
To do this, access your breaker or fuse panel and turn OFF the breaker or remove the fuse for the circuit the Wemo Dimmer WDS070 is on. Wait for 5 seconds and then turn ON the breaker or replace the fuse to restore power.
