This guide shows how to properly install the BoostCharge Magnetic Wireless Charging Car Dash Mount, PSU included (WIC011), using the built-in gel suction cup. Following these steps helps ensure a strong, stable attachment for safe, hands-free use while driving.
Step 1: Adjust the Mount Arm
-
Release the locking lever and bend the extending arm to your preferred viewing angle.
Once positioned, press the locking lever back into place to secure the arm.
Step 2: Clean the Dashboard Surface
-
Wipe down the area of the dashboard where the mount will be placed.
-
Make sure the surface is clean, dry, and free of dust or oils for best adhesion.
Step 3: Attach the Suction Cup
-
Peel off the protective film from the gel suction cup.
-
Press the suction cup firmly onto the cleaned surface.
-
Allow it to dry for at least 20 minutes before use. For maximum stability, let it set for up to 48 hours.
Step 4: Maintain the Suction Cup
After long periods of use, wipe the suction cup clean if needed to restore adhesion before reattaching it.
Helpful Tips
-
Install the mount on a flat, smooth dashboard surface for best results.
-
Avoid placing the suction cup on textured, curved, or uneven areas.
-
Allowing the full 48‑hour curing time provides the strongest hold, especially in warm environments.
BoostCharge Magnetic Wireless Charging Car Dash Mount, PSU included (WIC011) Installation FAQs
Q1. Why does the installation require waiting time?
The gel suction cup needs time to fully bond with the dashboard surface. Waiting improves long‑term stability and prevents the mount from loosening.
Q2. Can I reposition the mount after installation?
Yes. Clean both the dashboard surface and the suction cup before reattaching to maintain strong adhesion.
Q3. What should I do if the suction cup loses grip over time?
Remove the mount and gently wipe the suction cup clean to remove dust or residue, then reinstall it following the same steps.
