text.skipToContent text.skipToNavigation

How to reset the WiFi settings on your Wemo Doorbell

If you change any settings on your WiFi such as the SSID or password, you can perform a WiFi reset on your Wemo Smart Video Doorbell, WDC010.  A WiFi reset will remove the WiFi settings on your Wemo® Doorbell without removing any other customizations.  Resetting the WiFi settings on the Wemo Doorbell requires you to remove it from its mount and press the reset button.

The Reset button on the Wemo Doorbell is located on the back of the unit.  You will need a Torx T6 security bit or screwdriver to unscrew the security screw on the bottom of the Wemo Doorbell to remove it from the mounting plate.  A Torx T6 security screwdriver was included in the package of the Wemo Doorbell. 

 
Step 1:  Unscrew the security screw from the bottom of the Wemo Doorbell and remove it from the mounting bracket.
 
sf318681-001_en_v1.png

Step 2:  Use a small object like a pen or the Torx screwdriver tip to press and hold the reset button until the lights on the doorbell turn yellow (about 8 to 10 seconds).  Release the reset button once the lights turn yellow.
 
sf318681-002_en_v1.png

Step 3:  Wait for the status light and light bar on the video doorbell to turn blue.

Step 4:  On your mobile device's settings screen, go to Wi-Fi and tap on the SSID of the Wemo Doorbell seen under SET UP A NEW DEVICE.  Then, tap Add to Home & Wi-Fi.

 
sf318681-003_en_v1.png

NOTE:  Alternatively, you can go to the Home app and tap on the Wemo Doorbell tile. Then, tap on the gear icon.
 
sf318681-004_en_v1.png

sf318681-005_en_v1.png

Step 5:  Tap Update Accessory Wi-Fi Settings.  This should let the Wemo Doorbell join your network again.
sf318681-006_en_v1.png

Step 6:  Place the Wemo Doorbell back on the mounting bracket and put the security screw back in place.

Your Wemo Doorbell will reboot and go back into setup mode.  This will take about 30 seconds.  Once the status lights are flashing on the front of the doorbell, hold your phone next to the doorbell to go through setup and add it back to your network. 
 

Was this support article useful?

Thank you for your feedback.

Additional Support Questions?

Search Again

CONTACT SUPPORT

Loading Shopping Cart...