When your TuneBase™ FM does not charge or detect your iPod® or iPhone®, your TuneBase's fuse might need replacement. This article will provide you with instructions on how to change your TuneBase's fuse.
IMPORTANT: You will have to use pliers in replacing your TuneBase's fuse.
NOTE: Before you proceed, make sure that you have performed all the troubleshooting steps provided here.
Check the table below to verify if you have the correct fuse for replacement:
Parts |
Requirements |
Fuse Type |
Glass Tube Fuse |
Current Rating |
1 A |
Voltage Rating |
250 V |
Diameter |
5 mm |
Length |
25 mm |
Step 1:
Disassemble your TuneBase™ FM on a clean and level surface. Make sure that all parts are present.
Step 2:
Replace the fuse by removing the front of the cigarette lighter adapter.
NOTE: The front of the cigarette lighter adapter is spring-loaded so it should be carefully removed.
Step 3:
Re-assemble your TuneBase™ by following the correct sequence of the parts in the image below: