This article will show you how to set up and use the Belkin MMA001.
Before you begin, make sure to do the following:
Â
- Insert three AA batteries to the Belkin MMA001. For complete instructions, click here.
- You must have the Belkin Mount app installed to your MagSafe®-compatible phone. To get the app, click here for instructions.
Step 1:
Attach a MagSafe-compatible phone to the Belkin MMA001.
Â
Attach a MagSafe-compatible phone to the Belkin MMA001.
Â
QUICK TIP:  Your phone can be adjusted manually 15° forward or 45° back.
Â
Step 2:
Press and hold the button on the side for 2 to 3 seconds or until you see a blinking blue light above the button.
Â
Step 3:
Open the Belkin Mount app and follow the on-screen instructions.
Â
NOTE:Â Â You will see the following screens during initial setup.
Â
Step 4:
Once you have completed the initial setup, the light on the mount should be blinking white.
Â
Step 7:
On the next screen, tap OK.
Â
Step 8:
Tap on Start Broadcast.
Â
Step 9:
Open the app you selected in Step 5.
Step 10:
Choose either Front Camera or Rear Camera on the app. It should be the same as the one you chose on Step 6.
QUICK TIP:Â To toggle between face tracking (solid white light) and standby (blinking white light) modes, press the button on the mount.
Â
| Face tracking mode | Standby mode |
 |  |
Â
The camera on your phone should now be following your face. When this happens, you can already start recording videos or a live stream.
Â
Â
