Step 1: Look at the bubble

• If it is a clear bubble with no dot, it is usually trapped air.
• If it has a tiny dot in the middle, that dot is dust.

Step 2: Decide what to do

• Small clear bubbles: wait 24–48 hours. They often shrink on their own.
• Big bubbles, edge bubbles, or any bubble with a dot: fix it now by lifting and reseating.

Step 3: Get your tools

Grab these from the kit:

• Cleaning cloth
• Dust removal sticker
• Installation tray (optional, but helpful for alignment)

Step 4: Fix a clear air bubble (no lifting needed)

• Wrap your finger in the cleaning cloth.
• Press in the center of the bubble.
• Push the air toward the nearest edge in one slow motion.
• Hold pressure for 10 seconds, then let go.
• Repeat 2–3 times.

Step 5: Fix a bubble with dust (lift and reseat)

• Wash and dry your hands.
• Turn off any fan near you. Dust floating around makes it worse.
• Lift the corner closest to the bubble very slowly. Only lift enough to reach the dusty spot.
• Use the dust removal sticker to tap the dust off the phone screen.
• If the protector’s sticky side picked up dust, tap that spot lightly with the dust sticker too.
• Lower the protector back down slowly.
• Press the center, then press outward to push air out.

Step 6: If the edge keeps lifting

• Remove the phone case and check if it is pushing on the protector.
• Press and hold the lifting edge for 30 seconds.
• If it still lifts, lift that edge slightly, remove dust with the dust sticker, and reseat.

Step 7: Final check

• Wipe the screen with the cloth.
• Look under a bright light.
• If the bubble is shrinking, you are done.

Important: What not to do

• Do not put water or soap under the protector.
• Do not peel it off and reapply repeatedly.
• Do not press hard with a card or a tool.