The Belkin SoundForm Dot Wireless Earbuds are designed to deliver convenient wireless audio for music, calls, and more. Before using the earbuds for the first time, make sure they are properly placed in the charging case and paired with your mobile device. This guide will walk you through the setup process shown in the included quick-start illustration.
Before You Begin: Choose the Correct Ear Tip Size
For the best comfort and sound quality, select the ear tip size that fits your ears best.
-
Choose from the included Small (S), Medium (M), or Large (L) ear tips.
-
Gently attach the ear tips to each earbud.
-
Insert the earbuds and adjust them until they fit securely and comfortably.
A proper fit helps improve audio quality and passive noise isolation.
Set Up and Pair Your Earbuds
Step 1: Remove Any Protective Stickers
Open the charging case and check the earbuds for any protective films or stickers covering the charging contacts.
If present, remove them before charging or pairing.
Step 2: Place the Earbuds in the Charging Case
Insert both earbuds into their corresponding charging slots inside the case.
Ensure each earbud is seated correctly and making contact with the charging pins.
Step 3: Close the Charging Case
Close the lid completely and allow the earbuds to initialize inside the case.
Step 4: Reopen the Charging Case
Open the charging case again while keeping the earbuds inside.
Step 5: Wait for Pairing Mode
The earbuds will automatically enter Bluetooth® pairing mode. An LED indicator on the earbuds or charging case may begin flashing to indicate they are ready to connect.
Step 6: Connect to Your Device
-
Open the Bluetooth settings on your phone, tablet, or computer.
-
Ensure Bluetooth is enabled.
-
Look for SoundForm Bolt in the list of available devices.
-
Tap SoundForm Bolt to pair and connect.
Once connected, the earbuds are ready to use.
FAQs
1. Why can't I find "SoundForm Bolt" in my Bluetooth device list?
Make sure the earbuds are out of the initial charging state and the charging case is open. If the earbuds do not appear, place them back in the case, close the lid, reopen it, and try again.
2. Do I need to pair both earbuds separately?
No. The earbuds pair with each other automatically. You only need to select SoundForm Bolt once on your Bluetooth device.
3. What should I do if one earbud is not working?
Place both earbuds back into the charging case, close the lid for a few seconds, then reopen it and reconnect. Also ensure both earbuds are adequately charged.
Helpful Tips
-
Use the ear tip size that provides the most secure and comfortable fit.
-
Keep the charging contacts on the earbuds and charging case clean and free from debris.
-
Charge the earbuds and charging case fully before first use.
-
Store the earbuds in the charging case when not in use to keep them charged and protected.
-
If pairing issues occur, turn Bluetooth off and back on again on your device, then retry the pairing process.
Tip: For the best wireless performance, keep your connected device within Bluetooth range and avoid obstacles that may block the signal.
