Quick Start Guide | UltraCharge Wireless Car Charger Vent and Dash Mount

Quick Start Guide

UltraCharge Wireless Car Charger 25W (Vent and Dash Mount)

Model: WIC014 | Output: 25W | Connector: USB-C

Overview

This kit includes two ways to mount your magnetic wireless charging head: a suction-cup dash mount and a spring-loaded vent clip. Choose the mount that works best for your vehicle, then follow the steps below to install it and attach the wireless charger.

Option A: Dash Mount Installation

1–2. Position the arm

Unlock the lever and rotate the mounting arm upright, then rotate it back down to angle the suction base toward your dash or windshield.

3. Adjust the angle

Rotate the arm left or right to set your preferred viewing angle before mounting.

Remove the sealing film and press to lock

4–5. Stick and lock

Tear off the bottom sealing film, then press down firmly on the base and lock it in place. Leave it for 20 minutes to ensure the suction cup is stable before use.

Option B: Vent Mount Installation

1–2. Attach the vent clip to the mount arm, then rotate the knob to adjust the clip to the width of your vent fin.

3. Slide the clip between two vent fins until it's fully seated.

4. Rotate the knob to tighten the clip against the vent fin until it's secure.

Vent Compatibility

The vent mount works with standard horizontal, round, and vertical slat vents with flat fins. It is not compatible with spoke-style, cross-spoke, or single flat-panel vents that don't have separate fins to clip onto.

Step 3: Wireless Charger Installation

Attach the wireless charging head to the arm

1. Unlock and rotate the charging head to detach it from the arm.

2. Align the ball joint with the socket on the back of the charging head and press to connect.

3. Rotate the charging head to lock it onto the arm. Connect a USB-C cable to the port on the side to power the charger.

You're All Set

Dash mount

Vent mount

Note: The suction pad on the dash mount is reusable after washing. If it loses grip over time, rinse the adhesive surface with water, let it air dry, and re-stick.

Additional Support Questions?

Search Again