How to Set Up Your Stage Belkin PowerGrip (CTA006)

Before using your Stage PowerGrip for the first time, make sure it’s fully charged and that your phone or case supports MagSafe or magnetic attachment. Follow the steps below to test the magnet and connect via Bluetooth. 

 

I. Test the Magnet 

  1. Place your phone (or MagSafe-compatible case) onto the magnetic mount. 

  1. Check that the phone attaches firmly and doesn’t slide or fall off. 

  1. If the grip feels weak, reposition your phone or use a compatible magnetic case before continuing. 

CTA006

II. Set Up Bluetooth Connection 

  1. Press and hold the power button for 5 seconds until the indicator light turns on. 

  1. On your smartphone, go to Settings → Bluetooth. 

  1. Turn on Bluetooth if it’s off. 

  1. Select “Stage PowerGrip” from the list of available devices. 

  1. When connected, the indicator light stays on — your Stage PowerGrip is now paired and ready to use.

CTA006

III. Resetting Bluetooth Connection 

  1. Press and hold the power button for 8 seconds until the indicator light flashes. 

  1. On your phone, remove or forget “Stage PowerGrip” from the Bluetooth list. 

  1. Follow the Bluetooth setup steps above to reconnect. 

Was this support article useful?

Additional Support Questions?
Search Again