Upgrading the firmware of the Belkin Miracast Video Adapter

To update the firmware on your Miracast Video Adapter, you need to have a computer with Wi-Fi capabilities. Follow the steps below:

Step 1:

Using a computer, download the new firmware file.

NOTE: It is recommended that you save the file on a location that you will easily remember.

Step 2:

Turn OFF the Miracast Video Adapter by detaching it from the USB cable.

NOTE: Keep your TV powered ON. If the video adapter is powered by the TV, just unplug the adapter from the USB cable.

Step 3:

Press and hold the Multipurpose button located at the side of the Miracast Video Adapter. Do not release.

Step 4:

Continue pressing the Multipurpose button, then plug the USB cable back. Continue to press the button until the MIRACAST VIDEO ADAPTER/FIRMWAREUPDATE page appears on your TV screen.

Step 5:

Using a computer with Wi-Fi connection, look for the Wi-Fi-Video-Receiver network then connect to it.

Step 6:

Open a web browser such as Internet Explorer. On the Address bar, enter "192.168.16.1" then press [Enter].

Step 7:

When the Authentication Required prompt appears, enter "admin"in the User Name and Password fields.

You should then be logged in into the Miracast Video Adapter's web-based setup page.

Step 8:
Click Firmware Upgrade.

Step 9:

Click Choose File and select the firmware file you downloaded.

Step 10:
Click Upgrade.

IMPORTANT: The Miracast Video Adapter may take 5-10 minutes to complete the update process. DO NOT power OFF your TV or unplug the adapter from its power source. A yellow bar will indicate the update process' progress on the TV screen.

Step 11:

When the progress bar is filled, click Reboot.

A screen will appear on your TV indicating that the firmware update is in progress. DO NOT power OFF your TV or the adapter.

NOTE: The video adapter will do a self-reboot, then the home screen will appear.

Step 12:
Press and hold the Multipurpose button located on the side of the Miracast Video Adapter for at least 10 seconds to perform a factory reset. When the home screen reappears, the firmware update will be complete and the adapter will be ready to use.