G54/N150 Wireless Router Package Content
- G54/N150 Wireless Router
- Networking cable
- Power supply
- Quick Installation Guide
Product Specifications
Specifications | Description |
Data Link Protocol(s) | IEEE 802.11a/b/g/n |
Max. Link Rate | IEEE 802.11n up to 150 Mbps |
IEEE 802.11g up to 54 Mbps | |
IEEE 802.11b up to 11 Mbps | |
Radio Frequency Band | 2.4 GHz only |
Ports | 1 x WAN |
4 x LAN 10/100 Switch | |
Antenna Form Factor | 1 External dipole non-detachable |
Setup | Browser-Based Setup |
UPnP® | True |
Wireless Security Encryption Type(s) Supported | Pre-configured Security |
256-bit WPA™/WPA2™ encryption | |
64/128-bit WEP encryption | |
WPS Push Button Security | True |
System Requirements | Description |
Broadband Internet Service | Cable or DSL Modem with RJ45 Ethernet connection |
Operating System | Installed wireless Network Interface Card (NIC) and TCP/IP protocol |
Windows® XP 32 (SP3 or greater), Windows Vista® 32/64-bit, Windows® 7 32/64-bit, Windows® 8 32/64-bit, Windows® 8.1 32/64-bit, Mac OS X® 10.5 above | |
Minimum 1.8 GHz processor | |
Minimum 512 MB RAM | |
Browser | Internet Explorer® 7 or higher, Firefox®, Chrome™, Safari® |
LEDs
Router LEDs | Status/Description |
Router Status Light | Your router’s status is shown by the light on the front. |
Power Light | OFF – The router is not plugged into a power source. |
Solid Green – Power is supplied to the router. | |
WLAN Light | OFF – WLAN is disabled. |
Blinking Green – Wireless data is being transmitted. | |
Solid Green – WLAN is enabled but there is no data transfer. | |
Wi-Fi Protected Setup™ (WPS) Light | OFF – Idle |
Blinking Green – The router is listening for a WPS-enabled computer or other device. | |
Solid Green – This indicates a successful connection. The WPS LED turns solid green for five (5) minutes and then goes out when the router has made a secure connection with the computer or other device. | |
Blinking Green – This indicates a failed connection. The WPS LED blinks for 30 seconds after the WPS connection fails. | |
WAN Light | OFF – WAN connection is not active. |
Blinking Green – Data is being transmitted on the WAN port. | |
Solid Green – The router is connected to the Internet. | |
LAN Light | OFF – LAN connection is not active. |
Blinking Green – Data is being transmitted on the LAN port. | |
Solid Green – The router is connected to devices through Ethernet cables. |
For more information on how to manage this router, click on the links below.
Belkin G54/N150 Wireless Router, Frequently Asked Questions
Belkin N150 Wireless Router models