text.skipToContent text.skipToNavigation

How to manually restore the Wemo® Maker™, F7C043 to factory defaults

The Wemo® Maker™, F7C043 allows you to control low voltage devices such as blinds, sprinklers, irrigation system, pool pump, powered gates, etc. from anywhere. 

Follow the steps below to know how to manually restore your Wemo® Maker™, F7C043.
Step 1:  Remove the wire from the Relay to power OFF your Wemo Maker.

Step 2:  At the Wemo Maker’s back panel, hold down the Restore button.  
User-added image

Step 3:  While holding the Restore button down, reconnect the wire back into the Relay and continue to hold the button down for five seconds.  The status light will begin to blink orange to signify it is restoring.

Step 4:  Release the Restore button.  It should take about 60 to 90 seconds for the Wemo Maker to restore and reboot.  It will blink green and orange when finished.  

After resetting, you can proceed with setting up your Wemo Maker.  Click here for instructions on how to set up your Wemo Maker.

QUICK TIP:  Restart your Wemo app before proceeding with setup.

Was this support article useful?

Thank you for your feedback.

Additional Support Questions?

Search Again



    Have questions about your Belkin product? Contact our support team. CALL US

    A customer advocate will answer your questions. START LIVE CHAT

    Post your issue to Twitter, and we will reply in minutes. Tweet @BelkinCares

    File a CEW claim for equipment damaged by a surge or power issue while connected to your Belkin product.Learn More