How to manually restore the Wemo® Maker™, F7C043 to factory defaults

The Wemo® Maker™, F7C043 allows you to control low voltage devices such as blinds, sprinklers, irrigation system, pool pump, powered gates, etc. from anywhere.

Follow the steps below to know how to manually restore your Wemo® Maker™, F7C043.

Step 1: Remove the wire from the Relay to power OFF your Wemo Maker.

Step 2: At the Wemo Maker’s back panel, hold down the Restore button.

Step 3: While holding the Restore button down, reconnect the wire back into the Relay and continue to hold the button down for five seconds. The status light will begin to blink orange to signify it is restoring.

Step 4: Release the Restore button. It should take about 60 to 90 seconds for the Wemo Maker to restore and reboot. It will blink green and orange when finished.

After resetting, you can proceed with setting up your Wemo Maker. Click here for instructions on how to set up your Wemo Maker.

QUICK TIP: Restart your Wemo app before proceeding with setup.