If you wish to use your doorbell chime again, you will need to place your Wemo Doorbell back into Chime Mode. This can be done without restoring the Wemo Doorbell.
IMPORTANT: When using the Wemo Doorbell in bypass mode, make sure to leave the Chime Doorbell setting in the Home app set to off. This will reduce the risk of damaging your Wemo Doorbell.
What you will need:
- Wemo Doorbell
- Micro-USB cable
- 5V / 2.1A USB power supply
Turning ON Bypass Mode
Step 1: Connect the USB cable to the Micro-USB port on the back of the Wemo Doorbell.
Step 2: Press and hold the doorbell button until the status light bar turns purple. This will take about 10 seconds.
Step 3: When the light turns purple, release the button and wait until the status light bar turns white. This will take about 10 seconds. Once it turns white, you can disconnect the USB cable and continue installing the doorbell.
Turning OFF bypass mode
Step 1: Connect the USB cable to the Micro-USB port on the back of the doorbell.
Step 2: Press and hold the doorbell button until the status light bar turns green. This will take about 10 seconds.
Step 3: When the light turns green, release the button and wait until the status light bar turns white. This will take about 10 seconds. Once it turns white, you can disconnect the USB cable and reconnect the doorbell.
