How to install the Belkin ScreenForce® InvisiGlass™ Ultra Screen Protector using the Belkin Easy Align frame

The Easy Align frame is a unique screen protection system which delivers accurate but quick and easy application and alignment.  The Belkin ScreenForce® InvisiGlass™ Ultra Screen Protectors are also made up of Corning® Glass which has chemical strength that is able to resist deep scratches causing a glass to break.

QUICK TIP:  Screen protectors by Belkin undergo a standard test method for Film Hardness measurement called the ASTM D3363.  This test uses the Pencil Hardness scale with 9B being the softest and 9H being the hardest.  When your screen protector has a pencil hardness rating of 9H, this means your overlay can resist damage from materials that have a lower hardness rating than what the overlay is rated at.

With the Easy Align frame technology, putting your screen protector on your phone becomes effortless and easy to master.  Follow the instructions below to learn how.
Step 1:
Wipe your phone's screen with the microfiber cloth and remove any remaining dust with the dust removal sticker.

User-added image

Step 2:
Remove the Easy Align frame from the packaging.  Put the phone into the frame making sure that the back of the phone is flat.
User-added image

Step 3:
While holding the number 2 tab, remove the bottom lining with the number 1 tab.

User-added image

Step 4:
Slowly lower the protector on to the screen from top to bottom.
QUICK TIP:  You can lift and reapply the film as needed when bubbles appear.

User-added image

Step 5:
Use the Microfiber cloth to push out any air bubbles.

User-added image

Step 6:
If satisfied with the output, remove the top lining using the number 2 tab.
NOTE:  Peel gently so as to not accidentally pull up the film when you remove the top lining.

 User-added image

Step 7:
Remove phone from the Easy Align frame
User-added image

You have successfully installed your Belkin ScreenForce InvisiGlass Ultra Screen Protector.

Was this support article useful?

Additional Support Questions?
Search Again