IMPORTANT: Only use the power adapters supplied. Using incorrect power adapters may permanently damage your product.
Battery Performance
Rechargeable batteries in the Parent unit will last approximately 20 hours in normal use. New batteries do not reach full capacity until they have been in normal use for several days. The charge capacity of rechargeable batteries will reduce with time as they wear out, so reducing the performance time of the Parent unit. Eventually they will need to be replaced.
Step 1:
Plug one (1) of the power adapter cables into the socket marked
on the back of the Parent unit charger and plug the other end into the mains power wall socket and turn the power ON.
Plug one (1) of the power adapter cables into the socket marked
on the back of the Parent unit charger and plug the other end into the mains power wall socket and turn the power ON.
Step 2:
Activate the batteries by pulling the plastic tab away from the bottom of the Parent unit.
Activate the batteries by pulling the plastic tab away from the bottom of the Parent unit.
Step 3:
Place the Parent unit into the charger. The red light will illuminate on the charger and the battery icon will start a scrolling motion until it displays that the batteries are being charged.
Step 4:
Leave the batteries to charge for 16 hours to reach maximum charge.
Step 5:
Plug the remaining power adapter cable into the socket marked
at the back of the Baby unit and plug the other end into the mains power and turn ON.
Leave the batteries to charge for 16 hours to reach maximum charge.
Step 5:
Plug the remaining power adapter cable into the socket marked
at the back of the Baby unit and plug the other end into the mains power and turn ON. 
Step 6:
Press and hold the power
button on the Baby unit for one (1) second. The nightlight will briefly illuminate and then the green Link indicator will flash.
Step 7:
Press and hold the power
button of the Parent unit until all the LEDs briefly illuminate. The green Link indicator will flash and the display will show I’m Linking.
Press and hold the power
button on the Baby unit for one (1) second. The nightlight will briefly illuminate and then the green Link indicator will flash.Step 7:
Press and hold the power
button of the Parent unit until all the LEDs briefly illuminate. The green Link indicator will flash and the display will show I’m Linking.Once the units are linked, the green Link indicators of the Parent and Baby units will stop flashing and remain a steady green. The units are now ready to use.
IMPORTANT: The link confirmation between the two (2) units is vital for use so they can communicate. If the link between the units is broken at any time, the Link indicators on both units will flash green as they try to search for each other. After 30 seconds, if the link is still broken, they will flash red and you will also hear an alert signal from the Parent unit.
If the link is broken or you are encountering issues after set up, click here for troubleshooting instructions.
Positioning your units
The Baby unit should ideally be within 1 – 2 meters of your baby for best performance. If you place the Parent and Baby units too close together you will hear a high pitched noise, this is normal. The units are designed to be located at a distance from each other or in separate rooms.
