Wemo® Maker™, F7C043 System Specifications

The Wemo® Maker™, F7C043 allows you to control low voltage devices such as blinds, sprinklers, irrigation system, pool pump, powered gates and etc. from anywhere.  It is a device that brings Wemo internet connectivity and gives control to the do it yourself (DIY)-minded consumers.  Below are the system specifications of your Wemo Maker:

WARNING:  This device is a potential electrical shock hazard.  Basic circuitry knowledge is required to use this product.  Make sure you know what to do and the expected results from connecting devices to the Wemo Maker.


System Specifications
Wireless StandardIEEE 802.11 b/g/n
Operating Frequency2.4 GHz ~ 2.5 GHz
Spatial Stream1 x 1
Wi-Fi SecurityWEP 64 / 128 bit- WPA™ TKIP with pre-shared key, WPA2™ (AES /  TKIP) with pre-shared key
System RAM32 MB
System Serial Flash ROM16 MB
Antenna Peak Gain2 dBi External Dipole, grey
Operating ConditionsTemperature: 0°C to +40°C
Humidity: Max 80% RH
Storage Conditions for all componentsTemperature: -30°C to +70°C
Humidity: 90% RH (none condensing)

Technical Specifications
Relay/Sensor Contacts
  • Relay connections voltage no higher than:
​​- 24 V DC/AC at 1 ampere
  • Sensor connection voltage no higher than:
- 5 DC at 100 mA
- TTL Logic: Normally High, Triggered Low

Sensor Technical Specifications
  • Low: 0-0.8 V DC / High: 2.4-5 V DC
  • Normally High (Optimized for sensors with open collector outputs, using internal 4.7 k Ohm pull-up resistor)
Powered by:
  • Wemo Maker PSU: 5 V 100 mA max
  • Self-powered sensors: Requires voltage isolation between sensor and Wemo Maker

Related Articles:
Meet the Wemo® Maker™, F7C043
Wemo® Maker™, F7C043 System Parts and LEDs
Wemo® Maker™, F7C043 Frequently Asked Questions

Was this support article useful?

Additional Support Questions?
Search Again