IMPORTANT: Before using your Belkin QODE Keyboard, make sure to disconnect the Bluetooth® devices previously connected to it. Also, if the keyboard layout of your device is different from that of your Hardware Keyboard, you must change the keyboard language to update the output. Modifying only the iPad® or mobile phone language will not change the keyboard output. For more information on how to change this on your Android™ device, click here. For more information on how to change this on your iOS device, click here.
NOTE: The QODE App will prompt if there is an updated firmware available.
Before proceeding with the firmware update, you need to do the following setup steps.
Step 1:
Reboot the QODE Keyboard by holding the four corner keys down for 5 seconds until the light flashes red and blue alternately.
Step 2:
Remove keyboard pairing from iPad. You can do this by going to Settings > Bluetooth. Under My Devices, tap Forget This Device.
Step 3:
Fully shut down the App then relaunch. To do this, tap the home button twice to enter multitasker. Swipe left or right to find the QODE Update App and swipe up.
NOTE: You may need to repeat these setup steps if the update process fails.
Reboot the QODE Keyboard by holding the four corner keys down for 5 seconds until the light flashes red and blue alternately.
Step 2:
Remove keyboard pairing from iPad. You can do this by going to Settings > Bluetooth. Under My Devices, tap Forget This Device.
Step 3:
Fully shut down the App then relaunch. To do this, tap the home button twice to enter multitasker. Swipe left or right to find the QODE Update App and swipe up.
NOTE: You may need to repeat these setup steps if the update process fails.
After completing the setup steps above, proceed with the steps below to update the firmware of the QODE Keyboard.
Step 1:
Launch the App.
Step 2:
Tap Select Keyboard.
Launch the App.
Step 2:
Tap Select Keyboard.
Step 3:
Tap on your keyboard name.
Tap on your keyboard name.
Step 4:
Tap YES to confirm.
Tap YES to confirm.
Step 5:
Tap Pair to continue.
Tap Pair to continue.
Update will begin shortly. This should take 2-3 minutes.
IMPORTANT: Do NOT exit the App or touch the keyboard keys.
After a successful update, your QODE Keyboard will have the most current firmware.
