How to Install Titan  EcoGuard Red Light Screen Protector

• Microfiber Cloth
• Dust Removal Sticker
• Easy Align Tray with the screen protector pre-loaded

1. Ensure your work surface is clean and free of dust.
2. Remove any existing case or old screen protector from your phone.

3. Use the microfiber cloth to wipe the screen thoroughly, removing any dust, oil, or fingerprints.

1. Peel the backing off the dust removal sticker.
2. Cover the entire screen with the sticker, pressing down gently.
3. Carefully peel the sticker off. This will pick up any microscopic lint or dust particles that the cloth might have missed.

1. Bring the alignment frame close to your device.

2. Place the top of the frame (the end with the pull tab) over the top of your phone.

3. Gently push down on the frame until it is securely fitted around the edges of the device.

1. While applying gentle pressure on the frame to keep it steady, find the green "Belkin" tab at the bottom.
2. Pull the liner back towards you (away from the top of the phone) to reveal the adhesive.
3. Once the liner is removed, drag your finger vertically across the screen from top to bottom. This initiates the adhesion process and helps prevent large air pockets.

1. Lift the alignment frame off the phone by pulling up on the top tab.
2. The screen protector should now be seated on your screen.

1. If you see any remaining air bubbles, use the microfiber cloth to push them toward the closest edge of the screen.
2. Once all bubbles are gone, your phone is fully protected!