Wemo Smart Light Switch, F7C030 Requirements

Before installing the Wemo® Smart Light Switch, F7C030, you will need to comply with the requirements stated below.

Electrical Installation Requirements
  • A neutral wire - requires all three AC electrical connections at the wall switch.
  • A single pole light switch - the Wemo Smart Light Switch is not compatible with lights controlled by more than one switch.
Image
  • The light switch box must be 2 in deep.
 
Image

IMPORTANT:  The Wemo Smart Light Switch is not designed to work with metal faceplates as it interferes with the Wi-Fi signal.  It is also recommended only for residential and dry indoor locations.
 

Setup and Mobile Requirements
 

Wi-Fi Signal Requirement
 
Before setting up the Wemo Smart Light Switch, make sure the area where it will be placed has a strong Wi-Fi signal.  Hold your mobile device next to the switch and check the status bar which should have at least two or more signal bars.  

For instructions in setting up the Wemo Smart Light Switch, click on the link below:

Setting up the Wemo Smart Light Switch, F7C030

Was this support article useful?

Additional Support Questions?
Search Again