This article will guide you in setting up the ScreenCast AV Transmitter. Follow the steps below to know how:
Step 1:
Connect your ScreenCast AV transmitter to the included power supply and plug the power supply into an available electrical outlet.
Step 2:
Press the Power button on the transmitter.
Step 3:
Connect your HDMI AV source devices to the ScreenCast AV's HDMI ports. Make sure all your source devices are powered ON.
Step 4:
Connect the IR emitter to the ScreenCast AV transmitter's IR emitter port. The IR port is right beside the HDMI ports of the transmitter.
The four (4) ends of the emitter will relay commands from those devices' remotes in the following order:
ScreenCast receiver > transmitter > emitter > your devices
Your setup should now look like this:
Step 5:
Route the four (4) ends to the front of your video sources. These will relay the remote control commands from the ScreenCast receiver.