Installing and replacing the battery in the Wemo Stage WSC010

The Wemo Stage Smart Scene Controller, WSC010 is powered by a small CR2032 coin cell battery. You need to place the battery into the unit before you set it up. To install or replace the battery, follow the steps below.

Step 1: Remove the back cover of the Wemo WSC010 using a thin object such as a fingernail, nail file or flat head screwdriver.

Step 2: Place the CR2032 coin cell battery in the unit.

NOTE: When placing the battery, make sure to place the positive ( + ) side facing up. Reversing the battery can cause the unit to not work.

Step 3: Place the cover back on the Wemo WSC010 and snap it in place.

Was this support article useful?

Additional Support Questions?

Search Again