The Wemo® Maker™, F7C043 allows you to control low voltage devices such as blinds, sprinklers, irrigation system, pool pump, powered gates and etc. from anywhere. It is a device that brings Wemo internet connectivity and gives control to the do it yourself (DIY)-minded consumers. Below are the system specifications of your Wemo Maker:
WARNING: This device is a potential electrical shock hazard. Basic circuitry knowledge is required to use this product. Make sure you know what to do and the expected results from connecting devices to the Wemo Maker.
System Specifications
| Wireless Standard | IEEE 802.11 b/g/n |
| Operating Frequency | 2.4 GHz ~ 2.5 GHz |
| Spatial Stream | 1 x 1 |
| Wi-Fi Security | WEP 64 / 128 bit- WPA™ TKIP with pre-shared key, WPA2™ (AES / TKIP) with pre-shared key |
| System RAM | 32 MB |
| System Serial Flash ROM | 16 MB |
| Antenna Peak Gain | 2 dBi External Dipole, grey |
| Operating Conditions | Temperature: 0°C to +40°C Humidity: Max 80% RH |
| Storage Conditions for all components | Temperature: -30°C to +70°C Humidity: 90% RH (none condensing) |
Technical Specifications
Relay/Sensor Contacts
- Relay connections voltage no higher than:
- 24 V DC/AC at 1 ampere
- Sensor connection voltage no higher than:
- 5 DC at 100 mA
- TTL Logic: Normally High, Triggered Low
- TTL Logic: Normally High, Triggered Low
Sensor Technical Specifications
- Low: 0-0.8 V DC / High: 2.4-5 V DC
- Normally High (Optimized for sensors with open collector outputs, using internal 4.7 k Ohm pull-up resistor)
- Wemo Maker PSU: 5 V 100 mA max
- Self-powered sensors: Requires voltage isolation between sensor and Wemo Maker
Related Articles:
Meet the Wemo® Maker™, F7C043
Wemo® Maker™, F7C043 System Parts and LEDs
Wemo® Maker™, F7C043 Frequently Asked Questions
