text.skipToContent text.skipToNavigation

How to install the Belkin Anti-Glare & InvisiGlass Film

The Belkin Anti-Glare & InvisiGlass Film is a crystal clear screen protector designed to keep your iPhone® SE, iPhone® 6, iPhone® 6s, iPhone® 6 Plus and iPhone® 6s Plus safe from damage.  To learn how to install the film, follow the steps provided below.

NOTE:  This article applies to variants F8W645, F8W646,
F8W666F8W667, F8W727 and F8W728.
QUICK TIP:  It is highly recommended to watch the setup video before starting the installation.

Step 1:
Wipe your screen with the microfiber cloth and remove any remaining dust with the dust removal sticker.

User-added image
Step 2:
Remove the Easy Align Frame from the packaging.  Snap the frame on to the phone making sure the bottom lining does not touch the screen. 
NOTE:  The Belkin logo should be on the same side as the home button.

User-added image
Step 3:
While holding the number 2 tab, remove the bottom lining with the number 1 tab.

User-added image
Step 4:
Slowly lower the protector on to the screen from top to bottom.
QUICK TIP:  You can lift and reapply the film as needed when bubbles appear.

User-added image
Step 5:
Use the microfiber cloth to push out any air bubbles.

User-added image
Step 6:
If satisfied with the output, remove the top lining using the number 2 tab.
NOTE:  Peel gently so as not to accidentally pull up the film when you remove the top lining.

User-added image
Step 7:
Finally remove the Easy Align Frame.

User-added image
You should now have successfully installed your Belkin Anti-Glare & InvisiGlass Film.

Was this support article useful?

Thank you for your feedback.

Additional Support Questions?

Search Again


Loading Shopping Cart...