Switching HDMI sources requires a number of “hand offs” to happen between your TV, your source device, and the ScreenCast AV system. Because of this, it may take up to 10 seconds for the HDMI sync to resolve.
When I switch modes within my device (i.e., from Blu-ray disc playback to my BD player’s menu), why does the ScreenCast AV system have to reconnect?
Sometimes, the AV device different modes output content in different video resolutions. For instance, menus might be in 720p while a game or Blu-ray disc movie could be in 1080p. When the ScreenCast system switches resolutions, it needs to reconnect the transmitter and receiver, which is why you may experience a slight delay until the two (2) units can sync again.
My remote commands don’t seem to work.
Double-check that the IR emitter is fully seated in the back of the ScreenCast AV transmitter. You should also check to make sure that the receiver is flashing blue when you trigger a remote command — that means it is sending the command back to the transmitter. Finally, check to make sure that your remote batteries are fully charged and/ or fresh so that you get a full-strength signal from your AV remote.
What video formats can the ScreenCast AV system send to my TV?
- Video Compatibility:
- 480p, 720p (HDTV 2D & 3D), 1080i (HDTV), 1080p (FHDTV 2D & 3D)
- Supports 5.1 channel surround sound (96 kHz)
- 2D Video Resolution Compatibility:
- Up to 1080p 60Hz: 480i/480p/576i/576p/720p/1080i/1080p VGA, XGA
- 3D Video Support:
- 1920x1080p @ 24 Hz and 1920x720p @ 24 Hz
- 2-6ch LPCM @ 32 kHz-192 kHz
- Industry Standard: WHDI™
- WHDI™ does not compress or decompress; it uses a video modem approach to deliver the highest video quality.
Related Article:
Belkin F7D4515 Reference Guide