- Setting up the Wemo® NetCam using your iOS device
This article will help you set up your Wemo® NetCam using an iOS device.
The steps below cover the following products:
- Wemo® NetCam Wi-Fi® Camera with Night Vision, F7D7601
- Wemo® NetCam HD Wi-Fi® HD Camera with Night Vision, F7D7602
- Wemo® NetCam HD+ Wi-Fi® Camera with Glass Lens and Night Vision, F7D7606
Step 1: On your iOS device, install the Belkin NetCam App from the App Store®.
Step 2: Plug in the camera to a power outlet.
QUICK TIP: To avoid interference, don't place your device close to your router. You can also change the Wi-Fi channel of your router to reduce interference. To learn how to do this on your Belkin router, click here.
Step 3: On the back of the Wemo NetCam, flip the switch up to begin.
Step 4: On your iOS device, connect to the Wemo NetCam's Wi-Fi. Go to Settings > Wi-Fi and tap on the Wi-Fi name in the form of NetCamXXXX (the characters at the end vary per device).
NOTE: In this example, NetCamHD770C is used.
Step 5: Once your device is connected to the camera's Wi-Fi, launch the Belkin NetCam App then tap Yes when you're prompted to set up the camera.
Step 6: The App will display a Camera Preview. Tap Connect camera to Internet.
Step 7: Select your Wi-Fi, enter your Password when prompted, then tap Continue.
Give the camera a few moments to establish a connection.
Step 8: Follow the on-screen instructions to create an account and tap Continue when finished.
NOTE: Once set, your Username cannot be changed. If you wish to use a new username you have to create a new account. Take note of your Username and Password. You'll need them to access your camera through a web browser.
Step 9: Enter a Camera Name and Description, then tap Continue. The camera may take a few moments to register with the server.
Step 10: At the back of your camera, set the switch to DOWN position, then tap Continue.
Was this support article useful?
Thank you for your feedback.
Please tell us how we can make this article useful.