text.skipToContent text.skipToNavigation

Disabling the Dynamic Host Configuration Protocol (DHCP) Server on the Belkin router

DHCP (or Dynamic Host Configuration Protocol) is a protocol for assigning dynamic IP addresses to devices on a network.  With dynamic addressing, a device can have a different IP address every time it connects to the network.

The DHCP server option on Belkin routers is enabled by default but you have an option to disable it if you already have an existing DHCP server in your network.  Disabling the DHCP server allows your Belkin router to act as a switch when cascaded to the main router.

This article helps you disable the DHCP Server on the Belkin router.
 

Step 1:
Open any web browser on your computer.

Step 2:
In the address bar, enter "192.168.2.1" and press [Enter] on your keyboard.  You will then be directed to the router's web-based setup page.

Image
 

Step 3:
Click Login on the upper right corner.
 

Image


Step 4:
Once prompted to login, leave the Password field blank and click the Submit button.
 

Image
 

Step 5:
Under the LAN Setup section, click LAN Settings.
 

Image


Step 6:
Look for the DHCP Server section and check if it is set to Off.  Click the Apply Changes button to save the changes.  The new settings will only take effect once the router reboots.
 

Image



Related Videos:

Setting up the Belkin router using an iOS device (Video) Setting up the Belkin router using an Android™ device (Video)

Was this support article useful?

Thank you for your feedback.

Additional Support Questions?

Search Again