IMPORTANT: Australian law requires that Wemo® Wi-Fi Smart Light Switch, F7C030 should be installed by professional electricians such as Jim’s Electrical. To learn more, visit www.jimselectrical.com.au.
Electrical installation requirements
-
A Neutral wire (requires all three AC electrical connections at the wall switch)
-
A single pole light switch (not compatible with lights controlled by more than one switch)
Step 1: Download and install the Wemo App on your mobile device from the App Store® if you are using an iOS device or from the Google Play™ store if you are using an Android™ device.
Step 2: Enable the Wi-Fi feature of your mobile device and make sure it is connected to your Wi-Fi. This is required to ensure no error is encountered upon installation.
NOTE: If you have a dual-band router, Wemo can only connect to your 2.4 GHz band.
Step 2: Enable the Wi-Fi feature of your mobile device and make sure it is connected to your Wi-Fi. This is required to ensure no error is encountered upon installation.
NOTE: If you have a dual-band router, Wemo can only connect to your 2.4 GHz band.
Step 3: Once connected to Wi-Fi, look for the Wi-Fi Name of the Wemo Light Switch which will be WeMo.Light.xxx and tap it to connect your device.
NOTE: If you have multiple Wemo devices, connect to the one with the same Wemo ID at the back of the device. The Wemo ID is the word WeMo, followed by Wemo model, and then three alphanumeric characters.
QUICK TIP: If the Wemo Light Switch does not show up in the Wi-Fi search, you can try setting up with your mobile device near the Wemo Light Switch. Alternatively, you can press the Reset button on the faceplate of the light switch. For step-by-step reset instructions, click here.
Step 4: Once connected to the Wemo Light Switch, launch the Wemo App. Then, on the Let's get started! screen, tap Next.
Step 4: Once connected to the Wemo Light Switch, launch the Wemo App. Then, on the Let's get started! screen, tap Next.
Step 5: Enter your email address then tap Next.
Step 6: Select your Wi-Fi and enter your password.
Wait while the Wemo App connects to your Wi-Fi.
QUICK TIP: If the Wemo encounters difficulty connecting to the Wi-Fi, try refreshing your mobile device’s Wi-Fi and try connecting again. For more troubleshooting instructions, click here.
The Remote Access Enabled message will then pop up. By default, this feature is enabled.
Step 7: When the Wemo Light Switch setup is complete, the Wemo App will look for devices. If you have multiple Wemo devices, the Wemo App will display all these. You should see the Wemo Light Switch on the list.
QUICK TIP: You can customize the Name, Device Picture, and Reset Options of your Wemo Light Switch by tapping the pencil icon and then selecting the Wemo Light Switch.