HELP
  Status Network Settings System Information  
     
Network Settings
Host Name Configure the Host Name on this product.The name set here is used with WINS and "Network USB Hub Control Center", etc.The name must be different from those of other computers.
DHCP/BOOTP Enable/Disable DHCP/BOOTP protocol operations. DHCP/BOOTP is a protocol that obtains an IP address from the BOOTP server or DHCP server. If you use DHCP/BOOTP server, the DHCP/BOOTP server must be in the same network segment as this product. This product detects DHCP and BOOTP automatically. If more than 1 address gets returned, the IP address which is returned first will be assigned.
IP Address Configure the IP address on this product. The value must be configured in the format of a four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx".
Subnet Mask Configure the subnet mask on this product. The value must be configured in the format of a four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx". If the value is "0.0.0.0", the subnet mask corresponding to the IP address will be assigned automatically.
Default Gateway Configure the gateway IP address on this product. The value must be configured in the format of a four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx". The gateway must be in the network where this product exists. If the value is "0.0.0.0", this setting is disabled.
Network PnP Enable/Disable Network PnP function.
mDNS Enable/Disable mDNS function.
mDNS Service Name Configure the mDNS Service Name of this product.The name must be unique within the network.
LAN Interface Configure the physical network type. "AUTO" is recommended. If the LED on the hub is not turned on when you turn on this product, change the network type to the network type of the hub.
Primary WINS Server Assign the WINS server's address (primary). WINS server will resolve the IP address from the host name. Therefore you can use a hostname instead of the IP address when printing. The value must be configured in the format of a four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx".
Secondary WINS Server Assign the WINS server's address (secondary). WINS server will resolve the IP address from the host name. Therefore you can use a hostname instead of the IP address when printing. The value must be configured in the format of a four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx".
NetBIOS Scope ID The scope ID defines the computer group that recognized the registered host name.All computers which has the same scope ID can recognize each other.
IP Filter Mode Configure the IP filter operations. Available options are "ALLOW" and "DENY". If you select "ALLOW", only the data from the configured IP address range can be accepted. If you select "DENY", the data from the configured IP address range cannot be received.
Start Address
(Filter#0-#3)
Configure the start address of the IP filter. The value must be configured in the format of a four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx".
End Address
(Filter#0-#3)
Configure the end address of the IP filter. The value must be configured in the format of a four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx".
-TOP-